Description:
In this video you will learn how to check the oil level on the cable transmission on your Sherp Pro
1) Remove special bolt as shown (17mm), watch for oil to leak out.
2) Open sensor by unbolting (22mm), make sure the gearbox is level.
3) If there is no oil in the transmission you will need 500ml of oil to put into transmission .
4) Fill the oil through the hole seen from removing bolt. (you can use an adjustable wrench to take off the sensor if you do not have custom made socket. )
5) Fill with transmission oil to the top then put sensor back on, dont over tighten.
Parts) reinforced transmission 11002-01000-xxa-r